Crimestopper Security Products CS-2000DPII - Manual (Page 16)

16
CARJACK PROTECTION
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming
(option 14). See page 8. When the Ignition is on (running), press button #2 ( Trunk Symbol ). Parking lights
will flash TWICE to confirm the Carjack countdown sequence. 90 Seconds later, the unit will begin a Carjack
Cycle consisting of 20 seconds of pre-warning chirps turning into a full system activation with siren/flashing
light pulses for 5 min. To reset Active Carjack, IGNITION MUST BE ON, then press Button #2 again.
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming
(options 13 and 14). See page 8. We recommend this mode should only be used in serious situations. When
the Ignition is on (vehicle is running), and a door is opened, the Carjack countdown sequence will be initiated.
90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning
into a full system activation with siren/flashing light pulses for 5 min. To reset Passive Carjack, IGNITION
MUST BE ON AND DOORS MUST BE CLOSED, then press the override/program button (3) times.
FULL-TIME CARJACK
Use in case of extreme Carjack threat only. This feature provides full-time Carjack protection and must be
enabled before use through Alarm programming options (13) & (14). See page 8. EVERY TIME the Ignition
is turned ON or a door is opened, then closed with the Ignition ON, a Carjack countdown sequence will be
initiated. 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps
turning into a full system activation with siren/flashing light pulses for 5 min. You must reset the unit every
time the IGNITION is turned on or a door is opened and closed when the ignition is on.
To RESET : IGNITION MUST BE ON AND DOORS MUST BE CLOSED, then press override/program button
(3) times.
NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, Door
is opened, before entering VALET mode, and before Programming options or transmitters. It is always
in effect each time the Ignition is turned on and/or a door is opened with Ignition on.