Chicago Electric ROUTER TABLE WITH ROUTER 95380 User Manual
Page 12
SKU 95380
For technical questions, please call 1-800-444-3353
PAGE 12
To Install A Router Bit:
1.
WARNING! Make sure the Power
Switch of the Router Table is in its
“OFF” position and the Router Table is
not plugged into an electrical outlet.
2.
Fully insert the Router Bit (not included)
into the Collet Chuck (5A). Firmly tighten
the Collet Chuck with the two accessory
Wrenches (10B, 11B).
(See Figure E.)
To Adjust The Depth Of The Cut:
1.
ROUTER TABLE
POWER SWITCH
&
OUTLETS
DEPTH
ROD (18A)
KNOB (12A)
Figure F
Loosen the Lock Lever (8A). Then, loosen the Knob (12A).
(See Figure F and Assy. Diagram A.)
2.
Adjust the Router to obtain the required cutting
depth. Then, retighten the Lock Lever.
3.
Adjust the Depth Rod (18A) on the Router to read “0” when the router bit is
flush with the table top. Check to make sure that even if released with the
Lock Lever, the Router stops at the determined depth for repeated cuts.
Note: Minute depth adjustments (in 1/16” increments) can be made by raising or
lowering the Depth Rod (18A).
(See Figure F and Assy. Diagram A.)
COLLET CHUCK
(5A)
Figure E
WRENCH
(10B)
WRENCH
11B)