Chicago Electric ROUTER TABLE WITH ROUTER 95380 - Manual (Page 9)

SKU 95380 For technical questions, please call 1-800-444-3353 PAGE 9
ASSEMBLY INSTRUCTIONS
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram on pages 16 and 17.
CAUTION! Always make sure the Power Switch (2B) of the
Router Table is in its “OFF” position and the unit is unplugged from
its electrical outlet prior to performing any assembly procedures.
To Attach the Legs to the Table:
1.
Carefully turn the Router Table (5B) upside down.
2. Insert a Machine Screw (25B) through each of the 16 holes indicated with
an arrow in Figure A, below. Insert them so that the heads are near the top
of the table and the threads stick out to allow the Legs to be attached.
Figure A - Insert Machine Screws (25B)
upwards through the Table.
Table (5B)
Legs (1B)
3. Each Leg (1B) has four holes at its top. Place those holes
over the ends of the Screws as shown in Figure A.
4. Secure the Legs to the Screws using the Spring Lock
Washers (17B) and Nuts (18B). Tighten securely.
REV 11c