Intex PURESPA 77" JET MASSAGE SPA 2014 - Manual (Page 10)

250
PO
S AVE THESE INSTRUCTIONS
(250PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 01/10/2014
English
Page 10
SET UP (continued)
7. Disconnect the infl ation hose (7) from the air valve and the infl ation pump, and attach the pressure
gauge
(5) to the air valve. The pressure gauge indicator should be in the green area for a properly
infl ated spa tub (see drawing 6). Repeat previous steps to add more air if necessary.
8. Replace the air valve cap back.
NOTE: The cap is designed to be screwed on and off. Never exert force as this could cause the
complete internal infl ation system of the valve to come loose. See “Spa Tub Air Valve Fastening” for
valve maintenance.
Infl ate the Spa Cover Air Bladder
1. Open the infl ation valve and insert one end of the infl ation hose (7) into the valve, the other end to the
electric air pump; turn on the pump to infl ate until the air bladder is fi rm to the touch but not hard (see
drawing 7).
2. Disconnect the infl ation hose (7) from the the valve and the electric air pump.
3. Close and recess the infl ation valve.
NOTE: If there is a need to add some air to the spa tub wall or spa cover air bladder after they have been
setup, refer to above “Infl ate the Spa Tub Wall” and “Infl ate the Spa Cover Air Bladder” sections.
For outdoor infl ation:
For outdoor use, it’s recommended to use manual pump to infl ate the spa tub and cover air bladder.
5
7
4
7
1 2
7
7
6
5
1
2
6. Turn off the electric air pump. Disconnect the infl ation hose (7) from the electric air pump, then connect
it to the manual pump to infl ate the spa tub for 1 - 2 minutes (see drawing 5).
IMPORTANT: Do not over infl ate or use high pressure air compressor to infl ate.
7
3.2 3.1