Intex PURESPA 77" JET MASSAGE SPA 2014 - Manual (Page 12)

250
PO
S AVE THESE INSTRUCTIONS
(250PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 01/10/2014
English
Page 12
OPERATION
On/Off Button: Once the unit is plugged in, use this button to active the control unit panel
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
Heat Button: Use this button to activate the heating system. The pump will heat the spa water
until the water temperature reaches the set temperature. After the current water temperature
drops 2°F below the set temperature the heating system will restart. When the fl ame icon on the
display is red, the heating system is activated. When the fl ame icon turns green, the water is at
the set temperature and the heating system is at rest.
NOTE: If the heating system is activated the fi ltration system will automatically start.
NOTE: After turning off the heating system the fi ltration system will continue to operate 24 hours.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is
Fahrenheit.
Temperature Adjustment Buttons: Pressing the Temperature Increase or Decrease
buttons will cause the LED to fl ash. When fl ashing you can adjust to the desired temperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to confi rm the new
value.
NOTE: The default temperature is 68°F (20°C).
NOTE: Temperature adjustment ranges from 68°F (20°C) to 104°F (40°C).
NOTE: Recommend not to set the water temperature more than 100°F (38°C).
Water Filter Button:
This button turns the fi lter pump on and off.
The water fi lter icon on the display is green when activated.
NOTE: The built-in hard water treatment function works automatically in conjunction with the
fi ltration system.
Water Jet Button: Use this button to activate the jet massage system. After 1 hour of
continues use, the jet massage system will automatically turn off. The water jet icon on the
displays is green when activated. The angle of the water jet nozzles inside the spa tub wall can
be adjusted manually.
WARNING: Do not run jet system when the cover is attached, air pressure may accumulate
inside the spa and cause irreparable damage and bodily harm.
Jet Air Control Knob: Use this to add a mixture of air with the water jet pressure. Turn the
knob clockwise to increase the mixture of airfl ow and counter-clockwise to decrease the mixture
of airfl ow.
LED Display: Once plugged in the LED displays the current water temperature automatically.
IMPORTANT: The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5. 4m/s).
• The jet function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
A: Heat Button
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
D: Temperature Decrease Button
E: Water Filter Button
F: Water Jet Button
G: Jet Air Control Knob
H: LED Display
I: On/Off
Button
F
E
D
C
B
A
H
I
G
SPA CONTROL UNIT PANEL
F
104
o