Intex PURESPA 77" JET MASSAGE SPA 2014 - Manual (Page 2)

250
PO
S AVE THESE INSTRUCTIONS
(250PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 01/10/2014
English
Page 2
Warning.......................................................................................... 3-5
Parts............................................................................................... 6-7
Set-up............................................................................................. 8-11
Operation....................................................................................... 12
LED Code Chart............................................................................. 13
Maintenance and Chemicals........................................................ 14-16
Storage........................................................................................... 16
Troubleshooting............................................................................ 17
Warranty......................................................................................... 18
TABLE OF CONTENTS
IMPORTANT
Once the spa is assembled and fi lled with water, you
must release all the air inside the control base unit fi rst
before running the spa or else alarm code E90 will
display on the control panel. To release the air:
•
Ensure the control panel is off; press the
button to turn it off.
• Unscrew the drain valve cap on the control base
side with a coin. The air has been released once
a steady stream of water is fl owing out from the
drain valve. Wait for 15 seconds and screw the
drain valve cap back.
• Press the button to activate the control panel
buttons, and then run the jet function by pressing
the button to push out any remaining air in the
system.
Repeat above steps if alarm code E90 is shown on the
control panel.