CLIFFORD 20.7 - Manual (Page 27)

27 © 2008 Directed Electronics. All rights reserved.
Smart start
Command
: Press three-times and then press .
Feedback
: The parking lights flash 5 times fast and 'Smart Start On" dis-
PLAYS
Notes
: Enables or disables the SmartStart feature. The smart start fea-
ture of this system will allow you to have the remote start ac-
tivate when the vehicle reaches a certain temperature (hot or
cold) or a certain voltage. The factory setting for temperature
high is 100 °F the setting for low is 0 °F. The voltage setting is
FOR
These settings can be adjusted or turned off by your installer
when using the Bitwriter.
To activate the Smart Start Mode with a manual transmission:
Enter the MTS procedure. 1.
%XIT 2. button on the remote (the vehicle will
shut down when locking).
Press the
3. button on the remote 3 times and then press the button.
The 2 way remote will beep once and "Smart Start On" is displayed in 4.
THE
5.
smart start mode
The vehicle will now remote start when the cabin temperature reaches
6.
the programmed thresholds or when the vehicle battery reaches the pro-
grammed voltage.
THE
Details:
Smart start uses temperature and voltage settings to determine when the
vehicle should start and run. If any changes to temperature or voltage are made
using the Bitwriter programming tool Smart start activation is affected.