Install the lights, Attach the emergency release rope and handle, Installation step 7 – Craftsman 139.53915D User Manual

Page 18: Installation step 8

Advertising
background image

18

INSTALLATION STEP 7

Install the Lights

• Press the release tabs on both sides of lens. Gently rotate lens

back and downward until the lens hinge is in the fully open
position. Do not remove the lens.

• Install a 100 watt maximum light bulb in each socket. Light

bulb size should be A19, standard neck only. The lights will
turn ON and remain lit for approximately 4-1/2 minutes when
power is connected. Then the lights will turn OFF.

• Reverse the procedure to close the lens.

• Use A19, standard neck garage door opener bulbs for

replacement.

NOTE: Use only standard light bulbs. The use of short neck or
speciality light bulbs may overheat the endpanel or light socket.

INSTALLATION STEP 8

Attach the Emergency Release Rope and Handle

• Thread one end of the rope through the hole in the top of the

red handle so “NOTICE” reads right side up as shown. Secure
with an overhand knot at least 1" (2.5 cm) from the end of the
rope to prevent slipping.

• Thread the other end of the rope through the hole in the

release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet (1.83 m) above the

floor. Ensure that the rope and handle clear the tops of all
vehicles to avoid entanglement. Secure with an overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut end with
a match or lighter to prevent unraveling.

To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
• If possible, use emergency release handle to disengage

trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.

• NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

• NEVER use handle to pull door open or closed. If rope knot

becomes untied, you could fall.

Lens
Hinge

100 Watt (Max)

Standard Light Bulb

Release Tab

100 Watt (Max)

Standard

Light Bulb

To prevent possible OVERHEATING of the endpanel or light
socket:
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.

Trolley
Release Arm

NOTICE

Emergency
Release Handle

Overhand
Knot

Trolley

Advertising