Cobalt Networks 9011 - Manual (Page 11)

9011 Owner’s Manual
••••
(V 1.0) Page 11 of 22
Rear Module Installation (Optional)
If you are installing the card in a 8310-C-BNC or 8310-BNC frame (one with a 100 BNC rear module
installed across the entire back plane), skip this section.
If you are installing the card into a slot with no rear module, you should have ordered and received the
RM-9011-A module. You will need to install it in your 8310 frame before you can connect cables.
Use the following steps to install a rear module in an 8310 openGear TM frame:
1. Refer to the openGear TM 8310 frame Owner’s Manual, to ensure that the frame is
properly installed according to instructions.
2. On the rear of the 8310, locate the card frame slot.
3. As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module Installation
4. Align the top hole of the rear module with the screw hole on the top edge of the 8310
back plane.
5. Using a Phillips driver and the supplied screw, fasten the rear module to the 8310
back plane. Do not over tighten.
All modules are installed using the same method above.
The following section contains a drawing of the RM-9011-A module.