Cobalt Networks 9011 - Manual (Page 16)

9011 Owner’s Manual
••••
(V 1.0) Page 16 of 22
Remote Control
In This Chapter
This section provides a detailed explanation on using remote control functions with your card.
DashBoard Control System Software
The DashBoard Control System enables you to monitor and control openGear TM frames and controller
cards from a computer. The DashBoard software and manual can be downloaded from the Cobalt
Digital Inc. website (www.cobaltdigital.com).
Using the Menus and Menu Descriptions
You must first install the DashBoard Control System software on your computer. Refer to the
DashBoard User Manual for software installation procedures and for using the DashBoard interface.
The following pages list the parameters from the menu tabs available in the DashBoard software when
connected to a 9011.
Menu Item Format Description
Product CDI-9011 The product name
Manufacturer
Cobalt Digital Inc. The manufacturer of the
product
Serial Number ############ The product serial number
Software Release
Number ### The release number of the
firmware in this card
PIC Software Build
Number ## The internal build number
of this software
Temperature
Degrees C / Degrees F The surface temp of the
board
+12 V Power Rail #.## W Positive Supply Power
-7.5 Power Rail #.## W Negative Supply Power
Power #.# W
Total power consumed by
the board
Card Info
(Read-only)
Input Signal ############
Detected standard of the
input signal.