Cobalt Networks 9011 - Manual (Page 15)

9011 Owner’s Manual
••••
(V 1.0) Page 15 of 22
Card Status LEDs
The card LEDs report the lock status of the device. See the table below for an explanation of each
function.
LED NAME DESCRIPTION
LOCK LED Flashes green when not locked to input signal. When locked illuminates steady
green. When S3 or S4 not at 0, indicates state of parameter.
NTSC LED
On when locked to NTSC input, off otherwise
PAL LED
On when locked to PAL input, off otherwise
RMT LED
reserved for future use
Reference Configuration and Termination
The 9011 can use either a reference connected to the openGear™ frame, or a reference connected
directly to BNC 2 to align the SCH phase of the output video. To use BNC 2 as the reference, set S12 to BNC-
2. To use the openGear™ frame’s reference, set S12 to FRAME and then select which of the two frame
references to be used using S11. It is important to note that the 9011 does not operate as a frame synchronizer.
The output video timing will always match the SDI input timing.
Factory Default Settings
The factory default settings are as follows
1) S1.1-3 Output is composite on all ports
2) S1.4 - Color is On
3) S1.5 – Test Pattern is Off
4) S1.6 – Setup is On
5) S1.7 – Output Sample Mode is 16:16:16
6) S1.8 – De-Jitter Filter is On