CDA HVG95 - Manual (Page 20)

20
500 mm 200 mm min
650 mm
450 mm
Figure 18
TECHNICAL INFORMATION FOR THE INSTALLER
In order to install the cooktop into the kitchen fixture, a hole with the dimensions
shown in fig. 19 has to be made, bearing in mind the following:
✓
Within the unit, between the bottom of the cooktop and the upper surface of a
shelf there must be a clearance of at least 30 mm.
It is absolutely essential that you place a separator between the base of the cooktop
and the built-in unit or the oven;
✓
The cooktop must be kept no less than 200 mm away from any side wall (fig. 18).
✓
There must be a distance of at least 60 mm between the back side of the cut-out
and the back of the countertop.
✓
There must be a distance of at least 650 mm between the hob and any wall cup-
board or extractor hood positioned immediately above (see fig. 18).
✓
If the hob is installed over a built-in oven, the built-in oven shall be provided with
cooling fan.
The two appliances shall be connected to the gas/electric supply with independent
connections.