CDA HVG95 - Manual (Page 31)

31
230 V
L1 N(L
2
) PE
SECTION OF THE SUPPLY CABLE - TYPE “H05V2V2-F”
resistant to temperatures of 90°C
WARNING: If the power supply cable is damaged, it must be replaced only
by an authorised service agent in order to avoid a hazard.
230 VAC 50/60 Hz 3 x 0,75 mm 2
✓
The electrical cable must be connected to the terminal board following the diagram
of Fig. 29.
The appliance must be earthed.
The manufacturer declines all responsibility for any problem caused by
failure to observe this rule.
Figure 29