Crimestopper Security Products RS901 RS900ER - Manual (Page 5)

REMOTE ENGINE CONTROL
INFINITY RUN MODE
This mode can only be engaged when "Idle Down" is being engaged. It allows the vehicle engine to
remain running INDEFINITELY after the programmed run time elapses. This mode is especially
desirable for protecting police, emergency, or work vehicles that need to be left running unattended.
This mode will allow the vehicle to be left running and unattended without the ignition key in the switch
preventing the vehicle from being stolen.
INFINITY RUN MODE – EXITING THE VEHICLE:
1) With engine running, press and hold the brake pedal down, then press the Start button on the
transmitter two times within 4 seconds.
2) Parking Lights will start flashing.
3) Turn Ignition switch OFF. Engine will remain running. The vehicle’s parking lights will flash for the
programmed run time of 10, 20, or 40 minutes and then switch to solid while motor runs indefinitely.
4) Exit vehicle (Arm alarm or remote lock doors if desired).
5) Engine will remain running indefinitely or until reset. See Turning OFF a Remote Started Engine OR
Entering a vehicle during "idle down"
TIMED SELF-START MODE
This mode allows the user to program the system to automatically start the vehicle every 1 to 4 hours.
This is very helpful in extreme cold climates where engine fluid freeze up can be a problem. The
transmitter (or brake pedal on RS901) is used to program time interval.
NOTE: This programming will remain from the time it is programmed until the next time the vehicle is
driven or Remote Started. This feature may not be available when starting is triggered by an ALARM
REMOTE OUTPUT or FACTORY KEYLESS ENTRY. Do not use this mode if the vehicle is in a closed
garage or setting!!!
PROGRAMMING SELF-START MODE:
1) Press and HOLD Remote Start transmitter button for 4 seconds. Lights will start flashing to confirm
self-start program mode. For RS901, Start Input wire must be active for 4 sec.
2) Within 12 seconds, press the Lock transmitter button or for RS901 press Brake Pedal:
(1) time for vehicle to start every 1 hour (2) times for vehicle to start every 2 hours
(3) times for vehicle to start every 3 hours (4) times for vehicle to start every 4 hours
(Lights will momentarily stop flashing every time you press the transmitter button or tap brake
pedal.)
3) After setting the desired self-start time interval, wait 4 sec. for program confirmation. Parking lights
will turn off for 2 seconds, then flash 1 to 4 times to confirm the set time. (i.e. 2 flashes = 2 hours start
IGN
OFF
START
PRESS AND HOLD
2X
FLASH FOR RUN
TIME, THEN SOLID