Crimestopper Security Products RS901 RS900ER - Manual (Page 8)

Main Alarm / Remote Starter Power Fuse(s) may need to be removed before service. This will further
prevent the service personnel from accidentally arming and triggering the system but most likely not
required.
!! WARNING !!: Remove main power fuse before jump starting or charging a
dead or low vehicle battery
TRANSMITTER PROGRAMMING
CODE LEARNING PROGRAMMING (EXCLUDES RS901)
This CoolStart™ remote engine starting system is code learning and will accept a total of 4 transmitters.
These units ship from the factory with two transmitters pre-coded to your system. Additional remotes
(sold separately) can be added by following the procedure below.
TRANSMITTER PROGRAMMING:
1) Open hood (Gray wire grounded), start engine with key.
2) Depress and HOLD the BRAKE PEDAL and the Program/Valet Button until parking lights begin to
flash. TACH wire must be connected to a valid tach source or lights will stay on solid and not flash.
3) Continue pressing BRAKE, but momentarily release then press program button again to get parking
lights on solid.
4) Within 4 seconds of parking lights on SOLID press LOCK button on the remote to be added.
5) Parking lights will flash once to confirm code acceptance.
6) Program mode will automatically exit 4 seconds after pressing the program switch in step #4.
7) When finished programming, turn engine off, CLOSE HOOD FIRST, Then press BRAKE PEDAL
once to clear parking lights.
TRANSMITTER PROGRAMMING:
IGN
START
OFF
UNTIL
FLASHING
PRESS AND HOLD BOTH
0
4
SEC
FLASH 1X
THEN
SOLID
BEFORE
PRESS AND RELEASE
HOLD AGAIN
START
+