Casio IT-3000 - Manual (Page 43)

E-41
10. Fasten Part A of the Paper Holder to
the Handheld Printer Terminal.
Press both ends of Part A to fasten to
the Handheld Printer Terminal.
11. Insert the projections on both sides of
Part into the grooves of Part B and
fasten to the Handheld Printer
Terminal with the four screws for the
Paper Holder.
12. While spreading apart both ends of
Part A ( ), remove Part A from the
Handheld Printer Terminal by lifting
up Part A until the projections reach
the upper edges of the grooves of
Part B ( ), and then press on Part C
and Part D from the left and right
sides ( ). Next, push on both ends
of Part A to fasten to the Handheld
Printer Terminal.
Remove the Holder
1. Check that the power is off. If the
power is on, always make sure to turn it
off by pressing the power key.
2. Remove the Paper Holder by following
the reverse procedure for "Attaching the
Paper Holder", and then attach the Roll
Paper Holder.
• Remove Part C and Part D using an
ordinary screwdriver as shown in the
illustration.
2
1
3 C
D
1
1
2
3
3
IT-3000_E_P33_53.p65 07.10.3, 5:38 PM 41