G-Shock GA110SN - Manual (Page 8)

Operation Guide 5145
79
Pressing  x A while the countdown is stopped will reset to the countdown start
time.
Pressing  x D again while the timer countdown is stopped will restart the
countdown.
Time Up Alert ■
The watch beeps for 10 seconds when the end of the countdown is reached.
Stopping the Time Up Alarm ■
Pressing any button while the alert is sounding will stop it.
78
Using the Countdown Timer ■
In the Countdown Timer Mode, press D to start, stop or resume the
countdown.
The time is counted down in one-second steps.  x
6HFRQGV
5HVHW
6WDUW6WRS
0LQXWHV
77
2.
Use D (+) and B (–) to scroll through numbers at
the current fl ashing digit.
Holding down either button changes the setting at  x
high speed.
The start time can be set in 1-second increments up
 x
to 60 minutes.
3.
When the setting is the way you want, press A to
exit the setting screen.
The watch also will exit the setting mode if you do not  x
perform any operation for about two or three minutes.

Ŏ
76
Countdown Timer
Use the C button to enter the Countdown Timer Mode as shown under “Modes
and Indicators” on page 17.
You can set the start time of the timer in units of one minute in the range of 1 to
60 minutes. The watch beeps for 10 seconds when the end of the countdown is
reached.
Setting the Countdown Timer Start Time ■
1.
In the Countdown Timer Mode, hold down A
for about two seconds until the minutes start to
fl ash on the display. This is the setting screen.
0LQXWHV
$ERXWVHFRQGV
75
City
Code
UTC
Offset
City Name
ANC –9 Anchorage
YVR
–8
Vancouver
LAX Los Angeles
YEA
–7
Edmonton
DEN Denver
MEX
–6
Mexico City
CHI Chicago
City
Code
UTC
Offset
City Name
NYC –5 New York
SCL
–4
Santiago
YHZ Halifax
YYT –3.5 St. John’s
RIO –3 Rio de Janeiro
FEN –2 Fernando de Noronha
RAI –1 Praia
The contents of the table are current as of December 2009.  x
Time differentials in the above table are in accordance with Coordinated Universal  x
Time (UTC).
The rules governing UTC offsets and summer time are determined by each  x
individual country.
74
City
Code
UTC
Offset
City Name
DEL +5.5 Delhi
KTM +5.75 Kathmandu
DAC +6 Dhaka
RGN +6.5 Yangon
BKK +7 Bangkok
SIN
+8
Singapore
HKG Hong Kong
BJS Beijing
TPE Taipei
City
Code
UTC
Offset
City Name
SEL
+9
Seoul
TYO Tokyo
ADL +9.5 Adelaide
GUM
+10
Guam
SYD Sydney
NOU +11 Noumea
WLG +12 Wellington
PPG –11 Pago Pago
HNL –10 Honolulu
73
World Time City Code List ■
City
Code
UTC
Offset
City Name
UTC
0
Coordinated
Universal Time
LIS Lisbon
LON London
MAD
+1
Madrid
PAR Paris
ROM Rome
BER Berlin
STO Stockholm
City
Code
UTC
Offset
City Name
ATH
+2
Athens
CAI Cairo
JRS Jerusalem
MOW
+3
Moscow
JED Jeddah
THR +3.5 Tehran
DXB +4 Dubai
KBL +4.5 Kabul
KHI +5 Karachi
72
Important! ■
If you are using the watch in Japan, be sure to select TYO (Tokyo) as your Home
City.
Selecting another city code will make it impossible to receive the time calibration
signal, which will cause the watch’s time setting to be off.
71
1.
In the World Time Mode, use D to select the
city you want to use as your new Home City.
2.
To swap, hold down A and B at the same
time until the watch beeps.
This will make the World Time city you selected in  x
step 1 (New York) your new Home City.
Your previous Home City (Tokyo) will be your new  x
World Time city.
&LW\FRGH
:RUOG7LPH
70
Swapping Your Home Time and World Time Cities ■
You can use this procedure to swap your currently set Home Time and World Time
cities.
Example : To swap a Tokyo (TYO) Home Time setting with a New York (NYC)
World Time setting
Home Time World Time
Before swapping
Tokyo (TYO)
10:08 p.m.
Standard time
New York (NYC)
9:08 a.m.
Summer time
After swapping
New York (NYC)
9:08 a.m.
Summer time
Tokyo (TYO)
10:08 p.m.
Standard time