G-Shock GA110SN - Manual (Page 9)

Operation Guide 5145
89
Setting an Alarm Time ■
1.
In the Alarm Mode, use D to display the alarm
screen.
2.
Hold down A for about two seconds until the
hour digits start to fl ash, which indicates the
setting screen.
Displaying the setting screen turns on the alarm  x
automatically.
VHFRQGLQWHUYDO
+RXU
88
$ODUP6FUHHQ
D
+RXUO\7LPH6LJQDO6FUHHQ
2-second interval
$ODUPWLPH
87
Alarm and Hourly Time Signal
Use the C button to enter the Alarm as shown under “Modes and Indicators” on page
17.
The watch beeps for about 10 seconds when the Timekeeping Mode time reaches
the currently set alarm time. The Hourly Time signal causes the watch to beep every
hour on the hour.
Switching between Screens ■
In the Alarm Mode, press D.
Each press of  x D toggles between the alarm screen and the hourly time signal
screen.
When you enter the Alarm Mode, the screen that was displayed the last time you  x
exited the mode appears fi rst.
In the case of the alarm screen, the display alternates between the alarm ON/OFF  x
setting and the alarm time setting.
86
Split Time Indicator 6SOLWLQGLFDWRU VHFRQG 0LQXWHV 6HFRQGV
The split time screen cycles
alternately through the split
indicator (SPL), a minute/
second screen, and a 1/100
second screen.
85
Changing to another mode while a split time is displayed cancels the split time  x
operation.
To time 1st and 2nd place fi nishers ●
D A D A A
Start 1st Finisher
(Displays time of
1st fi nisher.)
2nd Finisher Displays time of
2nd fi nisher.
Reset
Pressing D while the split time is on the display stops elapsed time measurement,
leaving the split time on the display.
Press
A to exit the split time screen and display the total elapsed time when
measurement was stopped.
84
To measure elapsed time ●
D D A
Start Stop Reset
Pressing A while timing is stopped resets the stopwatch to all zeros.
Cumulative Time Measurement
Pressing
D to restart the stopwatch without resetting it to all zeros causes the
elapsed time measurement to resume from where it was last stopped.
To measure split times ●
D A A D A
Start Record split Release split Stop Reset
Pressing A while timing is being performed displays the split time screen, but timing
continues internally.
83
Paused Elapsed Time Measurement Screen  x
When elapsed time measurement is paused, the display alternates between a
minute/second screen and a 1/100 second screen at two-second intervals.
0LQXWHV
6HFRQGV
VHFRQG
VHFRQGLQWHUYDO
82
Stopwatch Display ●
Elapsed Time Screen  x
This screen shows the elapsed minutes and seconds.
0LQXWHV
6HFRQGV
81
Starting or Stopping an Elapsed Time Operation ■
In the Stopwatch Mode, press D to start, stop, or restart the stopwatch.
6SOLW5HVHW
6WDUW6WRS
80
Stopwatch
Use the C button to enter the Stopwatch Mode as shown under “Modes and
Indicators” on page 17.
The stopwatch measures elapsed time in units of 1/100 second up to 59 minutes,
59.99 seconds (60 minutes). When the maximum limit is reached, the elapsed time
returns to zero automatically and timing continues from there.