Time zone table – G-Shock GW-201NT-1 User Manual

Page 5

Advertising
background image

2016-5

More than 15
degrees too high

More than 15
degrees too low

Parallel to ground

Site Mode

The current time in all Site Mode sites is calculated in accordance with
the Greenwich Mean Time (GMT) differential for each site, based on the
current Home Site time setting in the Timekeeping Mode.

The GMT differential is the time difference of the time zone where the
site is located from Greenwich Mean Time.

The seconds count of the Site Time is synchronized with the seconds
count of the Timekeeping Mode.

GMT differential is calculated by this watch based on Universal Time
Coordinated (UTC) data.

Backlight Precautions

The electro-luminescent (EL) panel loses illuminating power after very
long use.

The illumination provided by the backlight may be hard to see when
viewed under direct sunlight.

The watch will emit an audible sound whenever the display is illuminated.
It does not indicate malfunction of the watch.

The backlight automatically turns off whenever an alarm sounds.

Auto light switch precautions

Avoid wearing the watch on the inside of your wrist. Doing so causes the
auto light switch to operate when it is not needed, which shortens battery
life.

The backlight turns off in about two seconds, even if you keep the watch
pointed towards your face.

The backlight may not light if the face of the watch is more than 15 degrees
off the parallel as shown below. Make sure that the back of your hand is
parallel to the ground.

Static electricity or magnetic force can interfere with proper operation of
the auto light switch. If the backlight does not light, try moving the watch
back to the starting position (parallel with the ground) and then tilt it back
toward you again. If this does not work, drop your arm all the way down
so it hangs at your side, and then bring it back up again.

Under certain conditions the backlight may not light until about one second
after you turn the face of the watch towards you. This does not necessarily
indicate malfunction of the backlight.

About the Battery

Whenever battery power is below a certain level, the flashing

indicator

appears, display characters appear dim, the backlight may fail to light, the
alarm may fail to sound and the auto light switch does not operate. For safety
reasons, the watch will not enter the Dive Time Measurement Mode when
battery power is low. This is indicated by the message

BATT

appearing

when you hold down

M

to enter the Dive Time Measurement Mode. Using

the watch while the battery is low can result in abnormal operation.
Even when the battery power is not low, backlight, alarm, and other
sustained high-power consumption operations can cause the flashing
indicator to appear temporarily. In this case, the

indicator should

disappear from the display in about 10 minutes. However, note that the
above listed functions, which are normally disabled when battery power is
low, are also disabled while the

indicator is temporarily flashing on

the display.

ALWAYS LEAVE BATTERY REPLACEMENT UP TO THE DEALER
WHERE YOU BOUGHT THE WATCH OR TO AN AUTHORIZED CASIO
DISTRIBUTOR. BE SURE TO SHOW THE FOLLOWING
INFORMATION TO THE PERSON REPLACING THE BATTERY.

Attention dealer or CASIO distributor
Be sure to use the following procedure when replacing the battery.

1. Open and remove the back cover.

Opening the back cover causes the message OPEN to appear on the
display.

If CLOSE appears on the display when you open the back cover,
replace the back cover. Wait for a few minutes and try again.

2. Remove the battery holder.
3. Remove the old battery and load a new one.
4. Replace the battery holder.
5. Touch the AC contact and the battery (+) side with metallic tweezers.
6. Close the back cover.

The message WAIT appears on the display about 20 seconds after
you perform the AC (all clear) operation in step 5 of the above
procedure, indicating that the watch is performing an internal self-
check for data errors. Note that the OPEN message remains on the
display during the internal self-check procedure, even after you close
the back cover.

+00

+01

+02

+03

+3.5

+04

+4.5

+05

+5.5

+06

+6.5

LONDON, DUBLIN, LISBON, CASABLANCA, DAKAR,
ABIDJAN
PARIS, MILAN, ROME, MADRID, AMSTERDAM,
ALGIERS, HAMBURG, FRANKFURT, VIENNA,
STOCKHOLM, BERLIN
CAIRO, JERUSALEM, ATHENS, HELSINKI, ISTANBUL,
BEIRUT, DAMASCUS, CAPE TOWN
JEDDAH, KUWAIT, RIYADH, ADEN, ADDIS ABABA,
NAIROBI
TEHRAN, SHIRAZ
DUBAI, ABU DHABI, MUSCAT
KABUL
KARACHI
DELHI, MUMBAI, CALCUTTA
DHAKA, COLOMBO
YANGON

–11
–10
–09
–08

–07
–06

–05

–04
–03

–02
–01

PAGO PAGO
HONOLULU, PAPEETE
ANCHORAGE,NOME
LOS ANGELES, SAN FRANCISCO, LAS VEGAS,
VANCOUVER, SEATTLE, DAWSON CITY
DENVER, EL PASO, EDMONTON
CHICAGO, HOUSTON, DALLAS/FORT WORTH, NEW
ORLEANS, MEXICO CITY, WINNIPEG
NEW YORK, MONTREAL, DETROIT, MIAMI, BOSTON,
PANAMA CITY, HAVANA, LIMA, BOGOTA
CARACAS, LA PAZ, SANTIAGO, PORT OF SPAIN
RIO DE JANEIRO, SAO PAULO, BUENOS AIRES,
BRASILIA, MONTEVIDEO

PRAIA

Some Cities in Same Time Zone

TIME ZONE TABLE

GMT

Differential

Based on data as of June 1998.

BANGKOK, JAKARTA, PHNOM PENH, HANOI,
VIENTIANE
HONG KONG, SINGAPORE, KUALA LUMPUR, BEIJING,
TAIPEI, MANILA, PERTH, ULAANBAATAR
TOKYO, SEOUL, PYONGYANG
ADELAIDE, DARWIN
SYDNEY, MELBOURNE, GUAM, RABAUL
NOUMEA, PORT VILA
WELLINGTON, CHRISTCHURCH, NADI, NAURU ISLAND

+07

+08

+09

+9.5

+10
+11
+12

Advertising