Produits Neptune 3648 KARMA - Manual (Page 3)

1
min. - max. Model
3648
3660 57 5/8"(146.4cm) - 59"(149.9cm)
46 1/4"(117.5cm) - 47 5/8"(121cm)
min.
- m
ax.
°6.0mm
6
9
11
/1
6
'‘
9'‘
Step1 Wall support installation
Draw a vertical line on the wall (Figure 1), centered on the
flood rim, while respecting the minimum and maximum seen
on the table below figure 1 and extend line on the base, paral-
lel to the rim.
Mark the locations for the screw holes on the wall at 9'‘ and 69
11/16'’ from the flood rim along the line.
Drill the holes with the appropriate drill bit and insert the wall
plugs.
Next attach the wall support brackets always checking their
alignment.
Step 2 ‘’U’‘ channel installation on fixed return panel
Clean thoroughly the base and the wall for dust and grease
before installing the “U” channels.
Temporarily install the fixed return panel #29 being careful
not to damage the base and verify that the panel meets the
base and the wall correctly.
Mark reference points on the flood rim where the fixed
panels end. (Figure 2)
Remove the fixed glass panel and place it securely aside.
2
Remove the protective poly-film from the flood rim before beginning the
installation of your door.
The designs in this guide are shown as right side installation, for a left
side installation mirror the images.
General information
INSTALLATION
Read the installation guide and warranty carefully and completely before proceeding or opening any hardware contents.
This shower door should be installed by a recommended professional installer.
Wear safety glasses, gloves and appropriate protective wear at all times during installation.
Verify that you have all the necessary tools and accessories as shown on page 2.
It is imperative to have a second person assisting on all steps of the
installation for safety and ease of installation.
All dimensions shown are nominal.
NEVER allow the glass panel to come into contact with any other hard surface (tile, stone, ceramic, etc.),
as it risks chipping or breakage.
Handle with care at all times.