Produits Neptune 3648 KARMA - Manual (Page 6)

7
7b
18
16
17
19
20
STEP 6 Support tube hook installation
Position the support tube hooks against the interior of the fixed
glass panel (Figure 6) inserting a plastic washer in between the
metal and the glass.
Screw gently and verify for proper integration of the plastic nut
inside the hole of the glass panel.
Do not strongly tighten at this step.
6 6
STEP 7 Door support tube installation
Insert the bumpers on the door support bar, ensuring that the plas-
tic nozzles are towards the interior of the bar (Figure 7).
Do not tighten them at this step.
Position the wall fixation ring at the end of the bar and tighten the
blockage screw.
Install the bar on its hooks, verify the ‘’front’‘ bumper is now close
to the fixed side panel and the ‘’back’‘ bumper is in between the
two hooks, position the bar perfectly so it is abutting the fixed side
panel.
Strongly tighten the hook blockage screws (Figure 7a).
Gently screw the tube to the fixed side panel (Figure 7b) loosen it
up a bit for level settling.
Using the provided plastic wrench, turn the white plastic nuts of the
hooks until the door support tube is slightly tilted towards the front.
(Figure 7c)
Strongly tighten the hooks and the support bar onto the fixed side
panel, making sure to keep the bar’s inclination.
7a
7c