Produits Neptune 3648 KARMA - Manual (Page 5)

STEP 3 Fixed side panel installation
Position the fixed side panel against the wall, verify for proper
integration in the interior of the ‘’U’‘ channels.
Verify the panel is perfectly steady and keep in position inserting,
if needed, the clear plastic shims inside the ‘’U’‘ channel.
Immediately remove any surplus silicone with a clean dry cloth.
Position the exterior plate of the bottom wall support bracket on
the other side of the glass with a clear plastic spacer in between
both of them and screw gently until partial resistance.
Make sure both parts of the support bracket are correctly aligned
and are never in contact with the glass.
Repeat the operation with the top wall support bracket, then
tighten gradually and entirely the screws, always verifying the
aligment.
3
STEP 4 Fixed panel installation
Repeat step 1 tracing a line 3/8'‘ (10mm) behind the end of the
return glass panel. (Figure 4)
Repeat step 2 cutting the ‘’U’‘ channel #7 7/8'‘ (22mm) shorter
than the line marking the end of the fixed side panel, keeping
the necessary space for the door guide.
Repeat step 3.
6
9
11
/1
6
'‘
9'‘
End of
fixed side
panel
3/8‘’
STEP 5 Towel bar installation
Position the bar against the fixed panel keeping a plastic
washer in between the metal and the glass.
Screw from inside inserting correctly the plastic protection into
the hole in the glass and the plastic washer in between the
glass and the screw. (Figure 5)
5
4