Produits Neptune SHOWER TOWER User Manual
Page 4
SHOWER TOWER INSTALLATION GUIDE
4
Determine the desired placement of the shower tower in consideration of the actual environment (height above floor,
water outlet, installation in a shower or tub...) as well as according to your height. Ideally, the top of the tower should
be situated 18 inches (460 mm) above the head of the tallest user. Make sure that the wall on which the tower will be
installed can support a load of 12 kg (25 lbs). Also take into account the final height of the body jets. Thoroughly clean
out the water supply pipe before installation to avoid any possible blockages.
STEP 1
Once height ‘‘A’’ is determined, proceed by installing the hot and cold water supply (½’’ male valve not included),
situated between 12’’ (300mm) and 14’’ (360mm) from the bottom of the tower, and a maximum of 7’’ (180mm)
apart (figure 1). The water outlets must be oriented towards the ground so not to disturb the eventual installation
of the tower. The wall openings through which the cold and hot water outlets pass should be filled to avoid the risk
of damage due to water infiltration.
STEP 2
64 1/2" (1638 mm)
Hot water
Cold water
22 3/4"
(578 mm)
10 1/4"
(260 mm)
Maximum 7"
overall
(180 mm)
12" to 14"
(300 mm to 360 mm)
FIGURE 1