Vermont Casting 2170 - Manual (Page 2)

2
Dutchwest Seneca
2006063
This manual describes the installation and operation of the Seneca Model 2170 catalytic-equipped wood heater. This
heater meets the U.S. Environmental Protection Agency’s emission limits for wood heaters sold after July 1, 1990.
Under specific test conditions this heater has been shown to deliver heat at a rate ranging from 9,400 to 22,800 Btu’s/
Hr.
Please read this entire manual before you install and use your new room heater. Failure to follow instructions may
result in property damage, bodily injury or even death. In addition to directions on installations and operation, this
manual includes directions on maintenance and assembly.
We recommend that you hire a professional solid fuel stove installer to install your stove, or to advise you on the
installation should you attempt to install it yourself.
The Seneca has been tested and is listed by Warnock Hersey of Middleton, Wisconsin. The test standards ANSI/UL
1482 and ANSI/UL 737 for the United States and CAN/CSA-B366.2 for Canada. The Seneca is listed for burning
wood. Do not burn other fuels. The Seneca is not listed for installation in mobile homes.
Proposition 65 Warning: Fuels used in gas,
woodburning or oil fired appliances, and the products
of combustion of such fuels, contain chemicals
known to the State of California to cause cancer,
birth defects and other reproductive harm.
California Health & Safety Code Sec. 25249.6
Specifications ................................. 3
Installation ...................................... 4
Assembly ...................................... 16
Operation ..................................... 17
Maintenance ................................. 22
Warranty ....................................... 30
Table of Contents Accessories
#6061 Rear Heat Shield
#6062 Bottom Heat Shield
#0134 Fire Screen