Keri Systems RPB-200 - Manual (Page 7)

RPB–200: RF Receiver
1530 Old Oakland Road, Suite 100 01825-200 Rev. B
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 7 of 8
RPB–200
Quick Start Guide
6.0 Troubleshooting the Receiver Installation
Problem Probable Cause Corrective Action
The controller does not
recognize the RPB-200. 1. One or more of the receiver’s
wiring connections are incorrect.
• Power down the controller and the receiver
and verify the wiring
• connections are correct per the instructions
provided in the Connections section on
page 2.
2. Insufficient power is being
provided to the RPB–200.
• Verify the power supply voltage and wiring
for the RPB–200 is correct (refer to the
RPB manual provided with the RPB unit).
3. The battery in the transmitter
card is weak or dead.
• Verify battery strength or replace the
battery.
4. PXL–100 ONLY – JP9 on the
OB–7 is installed.
• Refer to the OB–7 Quick Start Guide and
verify there is not a jumper across JP9.
The RPB-200 is
recognizing the
transmitter card, but not
showing up on the
software. 1. Data 0 and Data 1 are reversed. • Switch Data 0 and Data 1 positions.
The RPB–200 has a
short receive range. 1. The RPB–200 range adjustment
potentiometer should be
increased.
• Refer to the Receiver Installation sheet
provided by the Receiver’s manufacturer
for range adjustment instructions.
2. The antenna is shielded by
metal.
• Relocate the enclosure or the antenna away
from metal surfaces.
3. The battery in the transmitter
card is weak or dead.
• Verify battery strength or replace the
battery.