Keri Systems KRE-2 - Manual (Page 4)

KRE-2: Metal Enclosure
2305 Bering Drive 01854-001 Rev. E
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 4 of 4
Quick S
tart Guide
KRE-2
4.0 Controller Mounting
The PXL-250 controller is shipped in plastic, hinged-lid enclosure. Open the lid and use a
screwdriver to remove the controller from the plastic enclosure. Save the screws for controller
mounting in KRE-2.
Once the enclosure is mounted and the cabling is routed to the enclosure, the controller is mounted
into the enclosure (see Figure 4). There are four standoffs in the back of the enclosure to which the
controller is mounted. Use the four screws provided with the plastic enclosure to mount the
controller in the KRE-2. Simply align the controller over the four standoffs and insert the screws.
NOTE: Do not over-tighten the mounting screws as this can damage the controller.
Figure 4: Mounting the Controller Into the Enclosure