KERN & SOHN TEB 200-1 - Manual (Page 7)

TEB-BA-e-0510 7
6.2 Unpacking
Carefully remove the balance from its packaging, remove the plastic wrapping and
position the balance in its intended working location.
6.2.1 Installation
Install the balance in such a fashion that the weighing plate is absolutely horizonta.
6.2.2 List of items supplied
Standard accessories:
• Pocket balance
• Batteries
• Operating
instructions
6.3 Battery operation and change
• Battery conservation through automatic power-off 3 –4 minutes after ending a
weighing operation.
• When the battery power is used the display will show “LO”. Press the key and
change the batteries at once.
When the balance is not in use for a longer period of time remove batteries and keep
them separately. Leakage of battery liquid might damage the balance.
6.4 Initial start-up
A warm-up time of 1 minutes stabilises the measured values after switching on.
The accuracy of the balance depends on the local acceleration of the fall.
Please be sure to observe the information in the chapter on adjusting.
6.5 Adjustment
As the acceleration value due to gravity is not the same at every location on earth,
each balance must be coordinated – in compliance with the underlying physical
weighing principle - to the existing acceleration due to gravity at its place of location (
only if the balance has not already been adjusted to the location in the factory). This
adjustment process must be carried out during the initial start-up, after change in lo-
cation and variation of surrounding temperature. It is also recommendable to adjust
the balance periodically during weighing operation in order to obtain exact measured
values.
Battery change
1. Open the battery compartment cover located at
the bottom of the balance (Unblocking battery
compartment cover ( picture 1+2).
2. Insert 2 AAA type batteries (picture 3) .
3. Re-insert and lock the battery cover.( picture 4).