KERN & SOHN TEB 200-1 - Manual (Page 8)

TEB-BA-e-0510 8
6.6 Adjusting
Using a precision weight, the accuracy of the balance can be checked at any time
and adjusted.
Adjustment procedure:
Check that the surrounding conditions are stable.
A short warm-up time of about 1
minutes are recommended for stabilisation.
Press key approx. 3 seconds, ”CAL ” and then the exact weight of the adjusting
weight will appear the display.
Place the adjusting weight on the centre of the weighing plate.
“ F” will appear somewhat later, and then turn off.
In case of an adjusting error or a wrong adjusting weight “ E” appears in the display.
7 Operation
7.1 Overview of display (Units on display)
7.1.1 Weighing
Switch the balance on by pressing the key.
The balance will show “8888” for approx. 3 seconds and then change to “0”. Now it
is ready for use.
Important: If the display does not show 0, press the key.
Only now (!) place object on the weighing pan. Make sure that the weighing object
does not stripe or touch the housing or base.
If the object should be heavier than the weighing range allowance, the symbol “E”
(overload) will appear on the display .