KERN & SOHN FH 500 EXT - Manual (Page 4)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
FH 10– 500 EXT
FH_10-500-BA-e-1213 4
Auto-Peak-Hold-Function(Auto-Peak Mode)
Please press:
Min. limit peak save
This function allows to eliminate unwanted „Pre-Peak
values“ that are lower than the main peak value (Fp). The
“Min limit peak save” value (Fo) takes care, that these
“Pre-Peak values” are not saved.
The „Min limit peak save“ function is only possible in
Peak-Mode.
To set this Min limit value, please see the SET Menu in
section „Operating keys“.
Memory mode and average value (from up to 10 peak
values)
Saving peak values in the instrument
 Activating the „AUTO PEAK Function“ by PEAK key
 Deactivating the „Average Function“ by MEMORY
key
 Now, all peak values are stored automatically in the
instrument
 To browse through the stored values, please use the
▲ or ▼ keys. (The values will be shown in the upper
display segment)
 By pressing the MEMORY key, the average value of
the stored peak values can be shown (in the upper
display segment)

To delete every stored value, press the
▼-key in the
AVERAGE-Mode
6. Configuration of RS 232
SUB-D 9pm
Pin Signal Illustration
2 TxD Output signal
3 RxD Input signal
5 GND Ground
6 +1.6 to + 2 V Over upper limit
7 +1.6 to + 2 V Lower than lower limit
8 +1.6 to + 2 V OK
6.1 Output Protocol
RS-232 Parameter:
Baud rate: 9600
Data-Bit: 8
Parity: none
Stop-Bit: 1
The measured value is requested by the PC by the ASCII
Sign “9”.
The measured value that comes from the instrument has
this format:
e.g. 0011.70 means -11,70 Newton, if
Newton is the selected unit
||-----|
| |____> the other 6 places describe the
measured value as ASCII-Signs
|_______> the first place desribes the
direction of the force (0 = minus = Pressure;
1 = plus = Tension)
or: 1021.15 means +21,15 N (Tension)
|_______> the first place describes the
direction of the force (0 = minus = Pressure;
1 = plus = Tension)
or: 1021.15 means +21,15 N (Tension)
7. Warning
Intended use
The instrument you have acquired serves to determine the
measuring value of the material to be measured. It is
intended to be used as a “non-automatic“ instrument, i.e.
the material to be measured is manually and carefully
attached at the instrument. The measuring value can be
read off after a stable measuring value has been obtained.
Inappropriate use
Do not use the instrument for dynamic measuring. In the
event that small quantities are removed or added to the