Kuzma Stabi S 12inch 90629 - Manual (Page 5)

5
Basic setup:
Note: Carefully unpack parts which are in protective plastic bags.
Note: When assembling the motor tower and platter, ensure that the platter will not touch or
damage the motor pulley! Check the distance of the motor tower from the T base.
Note: While the parts are packed in plastic bags for protection, these are not intended to be
strong enough to lift or carry the parts.
If the turntable is supplied with a wooden platform, remove this and place in position. The
rounded part should be on the left. Locate the three small holes which correspond to the
intended position of the three black rubber rings on the main T base.
T base:
Remove the foam and lift the main T base (fig. 3) of turntable carefully as it is heavy and put
it on a shelf so that the side with the bearing is situated at 8 o' clock and the side with the
tonearm mounts at 2' o clock. But due its size it will not fit standard Stab S base. See fig 6.
Position T base for two tonearms 12& 9 inch + motor tower Fig 6.
Motor tower:
Lift the motor tower with the cable, being careful not to touch the black motor pulley.
Position it in the 8 'o clock position in the middle of the shorter length of the T base. See
fig.6. Turn the motor tower so that the mains switch faces forwards. The distance between
the motor tower and T base should be approximately 10 mm.