Kuzma Stabi XL 4 101014 - Manual (Page 6)

6
Distance of motor towers. Fig. 4.
Belts:
Place one belt over both motor pulleys in the lower running grooves and subplatter and
check by manual rotation that the belt runs smoothly in the middle of the grooves. Then place
the second belt in the top running grooves on the motor pulleys and subplatter.
Position of belts from lowest upwards:
1-old tower-right- lower groove
2-old tower-left- upper groove
3-new tower-front-upper groove( thinner support plate)
4-new tower-rear-lower groove ( thicker support plate)
Recheck the position of belts.
Power supply: PS XL 2=4
Position the PS on a firm surface away from signal cables and ensure there is adequate
ventilation, ie. leave a gap of at least 2 cm above the unit. Locate the 4 pieces of connecting
cables with DIN connectors. On the rear plate of the power supply and at the back of the
motor towers are DIN connectors, one for each motor. Connect cables by inserting plugs into
the sockets and rotate locking collars. It does not matter where each motor is connected. Plug
in the mains cable.