Kuzma Stabi XL 4 101014 - Manual (Page 7)

7
General description of PS XL 2 ( MCU):
The AC motor power supply generates dual sine wave ouput to control rotation and speed of
the AC sycnhronous motors. The signal is generated and controlled by a sophisticated
computer based program. This allows for very smooth generation of the sine wave with very
fine choice of speed. Each speed can be selected, finely adjusted independently and then
stored in the memory. PS is factory preset. Connect motor cables to motor outputs(any ).
Sometimes it will take a few hours for a new turntable to settle for the correct speed. When
the PS is unplugged preset speeds will be stored.
Technical data:
Mass: 2 kg
Size: 120x140x400 mm
Power consumption: 50w
Output: 33,45 rpm( 40-100Hz, 110V)
Mains: 110V or 230V ( 50-60Hz)
Check the belts again to ensure they run smoothly in the appropriate grooves.
Platter:
Carefully put the platter on the subplatter. The best way to do this is for one person to hold
the platter while another person positions it over the subplatter, helping to lower it down. Be
careful not to scratch the platter with jewellery etc. Check that the platter is resting on the
subplatter. Full speed should be obtained within 30 seconds (15-20). See front page.