LABEC AA-22N - Manual (Page 10)

6 DRY key
7 START/STOP key
10 RUNNING indication light
9 READY indication light
8 WATER indication light
This key selects the Fast sterilization cycle. With unwrapped instruments, you may use
the fast cycle by pressing the DRY key once, the indication light goes on and it indicates
that machine is in fast cycle mode. It can shorten the thermal drying time.
When you choose the right program, press this button then it starts a cycle. Keeping
pressing the key 3seconds before desiccation phase, the cycle of sterilization will be
quitted. Then it will enter 3 minutes dryness. In this program if you press the key again,
the program of dryness will be over at any moment. If you press the key at the end of
dryness, the cycle will be quitted directly.
Working light. It means sterilize program is working.
When the light goes on, the machine gets ready for sterilization, and the operator can
press
start key to start a cycle.
When the water volume is low, the light is glinting.
Operation manual
SEA Series Steam Sterilizers
6