Lake Lite LL-SPL-PAGODA-W-W - Manual (Page 2)

Look inside the light to see a small push button in order to
select power level or on/off position.
PO BOX 414
105 W. Simon St.
Laotto, IN 46763 Phone: 260‐918‐2758
Fax: 260‐918‐3540
E‐mail [email protected]
Use a screw driver to separate your light fixture. The
battery is NOT connected when shipped. You must
connect battery in order for the product to function. Use screw driver to remove cover & silicone pad. Connect
Battery: Caution! When plugging battery connectors
together, align notches before joining both connectors.
Forcing or connecting backwards will damage the light.
Battery
Connector
Internal Power/brightness
Level ON/OFF Button
Power Setting * Run Times
100% 6‐8 hrs
80% 9‐10 hrs
65% 11‐12 hrs
50% 13‐15hrs
25% 16‐20 hrs
15% 18‐24hrs
OFF OFF
* Note: Run times will vary significantly based on factors such as;
Sun Exposure, Season, Geographic Location, Shading, Installed
Location/Position, Battery Condition, Brightness Setting, etc… The
following run times should only be used as a general reference and are
based on a *FULL BATTERY CHARGE, and are not guaranteed. Consider
your local environment for the above reasons the light may NOT
receive a full charge and thus performance will be reduced.
1
2
3
www.lakelite.com
www.solarpilinglites.com
4
NEW: Magnet Switch
This light features a magnet switch underneath the solar panel
which allows you to change the power/brightness level without
re‐opening the light fixture. Wave the magnet over the solar
panel back and forth until you see the brightness change.
Note: to change
brightness after
installing the
light, wave the
magnet over
the solar panel
until brightness
changes to the
desired setting
Magnet
SOLAR PAGODA LITE
MODEL: LL-SPL-PAGODA-X
Screws
Screw Covers
TOP
Level 2
Level 1
Base
Mount
You MUST open the
light and connect
the battery for the
product to function
Cover & LED
Silicone Pad