Lake Lite LL-SPL-PAGODA-W-W - Manual (Page 3)

Use the provided screws to secure the silicone pad and
cover. Fully tighten screws to ensure the chamber is water
proof.
Place light onto piling and mark holes. Drill small pilot holes
in piling with drill bit. Use screwdriver to secure the light to
your piling with mounting screws – Not Included Verify that the top screws are tight to provide a good seal
for the lens. Verify that the base of the light is secured to
the piling.
7
8
PO BOX 414
105 W. Simon St.
Laotto, IN 46763 Phone: 260‐918‐2758
Fax: 260‐918‐3540
E‐mail [email protected]
Use Provided wrench and top screws to assembly your
light together. NOTE: The seal must be in the correct
position before tightening down the top to the base.
Silicone Pad
Battery
TOP
5
6
Mounting Screws
www.lakelite.com
www.solarpilinglites.com
SOLAR PAGODA LITE
MODEL: LL-SPL-PAGODA-X
Wood Piling
Screwdriver
Wood Piling
Cover with LED
Screws
Screw Covers
TOP
Level 2
Level 1
Base
Mount