Malone MPG353 - Manual (Page 2)

MALONE
R
Installation & Loading Instructions - MPG350 Stinger
3
Align
channels
to holes
. Insert the 1 3/4” Carriage Bolts down and
through the Extension Frame channels and
into the holes in the Mounting Plate.
See image 4.
. Place the Extension Frame on top of the Mounting
Plate with the raised block side facing up. The two
holes located on the end of the Plate should align
with the two channels in the Frame.
See image 3.
. Loosely thread the two T-knobs onto the Bolts.
Slide the Frame forward towards the Mounting
Plate until travel is stopped. Tighten both of
the T-knobs. See image 5.
TM
Step 2: Installing Carriers to Cross Bars
. Place the rear SeaWing (purchased separately)
onto the Stinger so that the mounting holes in
both units are aligned. See image 6.
4
6
5