Malone MPG353 - Manual (Page 3)

7
MALONE
R
. Place the Stinger with SeaWing assembly onto the
rear cross bar of the vehicle with the V-Block to
the rear of the vehicle. Swing the Jawz under the
bar and insert the second 70mm Bolt. See image 9.
Installation & Loading Instructions - MPG350 Stinger TM
. Loosely secure the second Bolt with a T-knob.
Position the assembly to the final desired
mounting location. Finish by firmly tightening
both of the T-knobs. See image 10.
8
9
10
. Insert a single 70mm Mounting Bolt down through
the SeaWing and Mounting Plate. See image 7.
. Insert 70mm Bolt through one hole of Jawz
adapter and loosely apply T-knob. See image 8.
Note: Additional bolt lengths available.
FOR MPG107 SeaWing: Insert bolt through Jawz
adapter and up through Mounting Plate and
thread into bottom mounting hole of SeaWing.
FOR MPG107 SeaWing: Do not attempt to use 70mm
mounting bolts. Call 1-800-295-0042 for standard
thread bolts (provided free of charge).
FOR MPG107 SeaWing: Install assembly on bar; insert
second bolt through Jawz and up through Mounting
Plate; thread into bottom hole of SeaWing.
FOR MPG107 SeaWing: Loosely secure the bolts.
Position the assembly to the final mounting
location. Firmly tighten bolts with wrench.