Maxim Integrated OneWireViewer, Version 1.5 - Manual (Page 8)

Sample Mission Viewer Tab
Mission Viewer Commands
Refresh Mission Results (to read device status, temperature log, and data log)
This allows a mission in progress to be watched without changing device viewers. If passwords are enabled for the device, the user must first use the Password
viewer command Set Software Passwords before access is granted to device data.
Start New Mission (to allow the user to enter all data necessary to start a new mission)
This command opens a new window in which the user enters the parameters for the next mission. If passwords are enabled for the device, the user must first use
the Password viewer command Set Software Passwords, before access is granted to device data.
Disable Mission (to stop a running mission)
This command stops a mission. The data collected remains stored in the device. If passwords are enabled for the device, the user must first use the Password
viewer command Set Software Passwords, before access is granted to device data.
When the Mission tab is active, the Mission viewer:
Automatically reads the device status, temperature log, and data log.
Automatically displays the device status on the Status tab.
Displays the temperature log as a graphic (if you open the Temperature Data Log tab).
Displays the humidity or data log as a graphic (if you open the Humidity Data Log or Data tab).
Allows the temperature scale to be changed between °C (default) and °F; the selected scale is memorized.
Allows activation of automatic rescaling of the log graphs.
Allows log data to be exported by using the clipboard or saving as a CSV (Excel) file.
Page 8 of 21