Maxim Integrated OneWireViewer, Version 1.5 - Manual (Page 9)

Sample Temperature Data Log Graphic (Humidity Data Log looks similar)
Start New Mission Window (default)
It is recommended that you synchronize the device's RTC to the PC. Enter the sampling rate in seconds (between samples). Enter the mission's Start Delay in
minutes. SUTA means Start mission Upon Temperature Alarm. Sampling rate, mission start delay, resolution, alarms, and rollover depend on the technical
requirements of the mission. See the respective device data sheets for details and guidelines.
Notes:
Mission Samples Count on the Status tab indicates the number of valid samples in the datalog memory. This number stops incrementing when the memory is
full.
Total Mission Samples indicates the number of samples taken during a mission. This number continues incrementing when a rollover occurs.
The Use 1-Second Mission Test? is not needed for B1 revision parts (date code 2007 and newer; serial numbers 005A900h to 005C09Fh, 0064200h and
higher).
Although the part is found as an alarming device, a Temperature High Alarm is not flagged on the Status tab. If there is a Temperature Low Alarm, both the
high and low alarm are flagged on the Status tab.
When a mission extends across time zones, the time shown in the exported data (clipboard or csv file) refers to the time at the location where the mission was
started.
Page 9 of 21