Microtel Series 100 User Manual
Page 12
H. POWERING UP THE SYSTEM
NOTE: IF THE UNIT ABOUT TO BE POWERED UP FOR THE FIRST TIME
CONTAINS HARDWARE FOR OPTIONAL FEATURES, READ THE
SUPPLEMENTARY INSTRUCTION MANUAL FOR THOSE FEATURES BEFORE
POWERING THE UNIT UP FOR THE FIRST TIME.
After the system has been mounted in a suitable area, the battery installed and
power, telephone and fault sensing lines connected, it may be powered up by
switching the "STANDBY - OPERATE" switch in the OPERATE position. This switch
is on the main printed circuit board inside the chassis and can be found by opening
the front panel of the metal chassis. When the unit is powered up, the front panel
indicators will flash in sequence for a few moments and the system will then say
"system ready". If this does not happen, turn the switch to the STANDBY position
and disconnect power and the telephone line from the unit. Contact qualified service
personnel or Microtel for instructions or repair.
8