Microtel Series 100 - Manual (Page 20)

acknowledgement has been accepted by saying, ["acknowledgement accepted, the
Intercall delay is xx hours"].
D. TEST AND ADVANCED KEYSTROKE SEQUENCES
Access to the remote control functions of the unit can be obtained at any time
communications are established with the unit, whether the unit or the user placed the
call.
After the call placed by the unit has been acknowledged by either method described
above, the system will accept the access code required for entry into the remote
control functions. When a call is placed to the system at any other time besides the
acknowledge call-back window of 60 seconds, the system will answer and deliver the
status message three times. If access to the remote control keystroke features is
desired, you must enter an acknowledgement (*) ["acknowledgement accepted"], and
then enter the access code.
You have two chances to successfully enter the access code.
After successful entry of the access code, the system will respond, ["system, ready"].
At this point, the following sequence commands are possible. Each sequence begins
with a key and, where applicable, ends with a * key.
To remotely enter or alter a telephone number (sequence # 1 x, where x is the
telephone number slot to be programmed):
1.
# 11 ["telephone number 1, ready"]
2. Enter desired telephone number, terminate the entry with a key. ["telephone
number 1 is nnn...n"]. If a pause is to be included in the telephone number use
the # key in the same manner as the DELAY key would be used locally.
To Read this data, use sequence # 2 x, where x is the telephone number to be read:
1.
# 21 ["telephone number 1 is nnn...n"].
To remotely enable the Intercom Mode (listening in to the monitored location):
1. #
95
This enables the intercom mode for a period of two minutes. After one minute and
forty five seconds the unit will issue a series of beeps to remind you to re-enter the #
key for an additional two minutes. To terminate this mode and remain on line with
system, depress the * key.
The following table summarizes all the remaining remote control sequences:
#11 enter telephone number 1 #21 read telephone number 1
#12 enter telephone number 2 #22 read telephone number 2
#13 enter telephone number 3 #23 read telephone number 3
#14 enter telephone number 4 #24 read telephone number 4
#15 enter telephone number 5 #25 read telephone number 5
#16 enter telephone number 6 #26 read telephone number 6
16