Microtel Series 100 - Manual (Page 21)

#17 enter telephone number 7 #27 read telephone number 7
#18 enter telephone number 8 #28 read telephone number 8
#19 enter telephone number 9 #29 read telephone number 9
terminate telephone number entries with a * key
telephone number 9 is the callback/callforward telephone number
#30 Request current fault status
#31 Request current system status--active (Run Mode) or not active (Halt Mode)
#32 Enter the intercall delay #33
#90 Hang up and go into Halt Mode
#91 Hang up and go into Run Mode
#92 Hang up and go into intercall Delay
#93 Hang up and go into the mode the system would have gone into on its own. This
is the same as simply hanging up on the unit.
#94 Enter the Delayed Run mode and hang up
#95 Intercom Mode--two minutes for each # entered
#99 Hang up and immediately call telephone number nine with the status message,
one time.
E. TEST AND ADVANCED KEYSTROKE SEQUENCES
A number of sequence commands are possible on the system front panel keyboard.
These are as follows:
ARCHIVE DATA RECOVERY
SEQUENCE 40 [the number of calls placed by the system]
SEQUENCE 41 [the number of acknowledgements returned]
SEQUENCE 42 [the number of calls placed to the system]
SEQUENCE 43 [the number of power faults]
SEQUENCE 44 [the number of resets or HALT key entries]
VOCABULARY TEST
SEQUENCE 50 [core vocabulary dump]
SEQUENCE 51 [application vocabulary dump]
SEQUENCE 52 flash test all front panel indicators (HALT to terminate this sequence)
PRESET ALL DATA VALUES TO DEFAULT
NOTE: Do not use these sequences unless you are thoroughly aware of the results,
which will occur--that is, the resetting of operational data.
SEQUENCE 60 preset all messages to default (Fault 1, Fault 2, etc.)
SEQUENCE 61 preset telephone numbers only (all become 0)
SEQUENCE 62 reset all archive data to 0 values
17