Microtel Series 250 User Manual
Page 12
H. POWERING UP THE SYSTEM
NOTE: IF THE UNIT ABOUT TO BE POWERED UP FOR THE FIRST TIME
CONTAINS HARDWARE FOR OPTIONAL FEATURES, READ THE
SUPPLEMENTARY INSTRUCTION MANUAL FOR THOSE FEATURES BEFORE
POWERING THE UNIT UP FOR THE FIRST TIME.
After the system has been mounted in a suitable area, the battery installed and power,
telephone and fault sensing lines connected, it may be powered up by switching the
POWER switch to the ON position. This switch is on the system’s front panel. When
the unit is powered up, the front panel indicators will flash in sequence [reset flash] for a
few moments. If this does not happen, turn the switch to the OFF position, disconnect
the power and the telephone line from the unit. Contact a qualified service person or
Microtel, Inc. for instructions.
8