Microtel Series 250 - Manual (Page 27)

D. PRODUCT WARRANTY
We warrant to the original purchaser the Microtel unit manufactured by us to be free
from defects in material and workmanship under normal use and service. Our
obligation under this warranty shall be limited to the repair or exchange of any part or
parts which may thus prove defective under normal use and service within one year
from date of installation by the original purchaser. In no event shall this warranty apply
to equipment after the expiration of eighteen (18) months from date of shipping to the
original purchaser whether or not the equipment is installed and which our examination
shall disclose to our satisfaction to be defective. THIS WARRANTY IS EXPRESSLY IN
LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING THE
WARRANTIES OR MERCHANTABLITY AND FITNESS FOR USE AND OF ALL
OTHER OBLIGATIONS OR LIABILITIES ON OUR PART, AND WE NEITHER
ASSUME, NOR AUTHORIZE ANY OTHER PERSON TO ASSUME FOR US, ANY
OTHER LIABILITY IN CONNECTION WITH THE SALE OF THIS MICROTEL UNIT OR
ANY PART THEREOF WHICH HAS BEEN SUBJECT TO ACCIDENT, NEGLIGENCE,
ALTERATION, ABUSE, OR MISUSE. WE MAKE NO WARRANTY WHATSOEVER IN
RESPECT TO ACCESSORIES OR PARTS NOT SUPPLIED BY US. THE TERM
“ORIGINAL PURCHASER”, AS USED IN THIS WARRANTY, SHALL BE DEEMED
TO MEAN THAT PERSON FOR WHOM THE MICROTEL UNIT IS ORIGINALLY
INSTALLED.
E. WARNING
Battery circuits remain active at all times. The potential exists for the battery to
discharge to a point where the battery cannot be recharged. To prevent an
unrecoverable depletion of the internally mounted battery, it is suggested that prior to
storage of the dialer unit or in the event of a prolonged interruption of 120 VAC power,
the internally mounted battery be disconnected. Disconnection is accomplished by
removing the wire termination spade from the positive (+) battery termination point
located on the battery.
Battery disconnection should also occur upon low battery indication as detected and
enunciated by the dialer unit and remain disconnected until 120 VAC power can be
restored.
Disconnection of the battery in an unpowered condition will require reconfiguration of
the units prior to placing the units back into service.
23