Clarion SR6000 - Manual (Page 50)

47 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s , i n c .
➤ Full trigger response 3 30 0 or 60 seconds: This determines how
long the full triggered sequence lasts. Some states have laws
regulating how long a security system can sound before it is
considered a nuisance. If your installer is programming the
security system with the ProSecurity Programmer, the full
triggered response can be programmed for any duration
ranging from 1 to 180 seconds.
➤ Automatic Engine Disable (AED) on or ooffff. The purpose of
this feature is to protect the vehicle from being stolen at all
times, regardless of whether or not the alarm is armed. If
AED is programmed on, the starter of the vehicle will be
disabled 30 seconds after the ignition is turned off. Once the
key is turned off, the LED will flash slowly (one-half its
normal armed rate) to indicate the AED arming cycle.
Thirty seconds later, the starter will be disabled. To start the
car, it will be necessary to disarm the system with the
remote. It is also possible to disarm the AED feature by
turning the ignition key to the RUN position and pressing
the Valet ® button the programmed number of times. AED is
also disabled when the system is in Valet ® mode.
➤ Siren tones and chirp volume. The output of the Revenger ™
Soft Chirp ™ siren consists of six different tones in sequence.
Any of these tones can be eliminated by a dealer, resulting in a
unique, easily identifiable siren sound. The chirps can be either
full volume or 6 6 d deecciib beellss q qu uiieetteerr than the full alarm blast.
note: This feature will only function if the FailSafe ®
Starter Kill relay has been installed.