NORAC UC4+BC+FC2 - Manual (Page 25)

23
Figure 25: Cable Configurations:C11, C12, C13 and C03
11. Connect four 2-pin Deutsch connectors
of C12 (R2D, R2E, R2F and R2G) to
the matching connectors of sprayer
cable(s). For each connector, the
function (e.g. “LEFT UP”) is labeled on
the branch wire of C12.
12. If your sprayer has a bypass valve, insert
the 2-pin tee (P2 & R2) on cable C13
into the bypass valve connection.
Connect S3 on cable C13 to T3 on
cable C11.
13. Connect the 6-pin Tower on the valve
cable (C03) to the mating 6-pin Shroud
(S6A) on C11.
14. Install the 2-pin connectors from C03
onto each NORAC valve as shown in
Figure 26.
15. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses.
Figure 26: Valve Cable Connections
16. Connect the CAN Node cable (C02B)
to the 4-pin AMP plug on C11.
17. Route the CAN Node cable (C02B) to
the roll sensors. Follow existing cables
and/or hydraulic lines.
18. Connect the sensor branch cable (C02)
to the 4-pin AMP plug on C02B.