NORAC UC5-BC-RG06 - Manual (Page 32)

29
Figure 27: NORAC Valve Block Details
10.3 Valve Block Mounting
1. A suitable mounting location for the valve block on the Rogator is illustrated in Figure 28.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 28: Valve Block Mounting