NORAC UC5-BC-RG06 - Manual (Page 36)

33
10. Connect each of the two H04 hoses to the corresponding left and right “B” port on the
NORAC valve block. Insert the 6FORXR 6MORT tee (F02) between the hoses and the
valve block.
11. The left raise line (H03) must now be connected to the left tee on the “B” port and the
right raise line (H02) must be connected to the right tee. Route the hoses to the tilt
cylinders. H03 is longer than H02 since the NORAC valve block is normally located on the
right side of the sprayer.
12. Connect H02 and H03 to the cylinders using the 12FORX 6MOR fittings (F05).
13. The existing lower lines do not need to be modified. Leave these lines connected to the
Rogator valve block.