Craftsman 137.21807 - Manual (Page 18)

18 19 18 19
5. Assemble the other upper supports
in exactly the same manner.
6. Attach one bottom support (5) to the
center of the leg using bolt (3) and
nut (4). This completes the front
frame section.
7. Assemble rear frame section in
exactly the same manner.
8. Join front-bottom and rear-bottom
frame assemblies using the bottom
support (7), bolts and nuts.
Fig. C
ASSEMBLE THE ROLLER WHEEL
TO STAND (FIG. D, E)
1. Place stand upside down on level
surface or floor.
2. Place bottom support bracket for roller
wheel (18) inner of the front leg (2).
3. Insert the bolt (12) through the roller
wheel bracket (11), front leg (2),
bottom support bracket (18) and nut
(13) as shown. Tighten the nut.
4. Attach the roller wheel (14) to roller
wheel bracket (11), bolt (15) and lock
nut (16) using square neck bolt (15)
and lock nut (16) as shown.
NOTE: Do not overtighten nut as
this will not allow the wheels to turn.
ASSEMBLY
ASSEMBLE STAND (FIG. A, B, C)
1. Unpack all parts and group by type
and size. Refer to the parts list for
correct quantities.
2. Attach four hooks (10) to the top
corner of the four legs (2) as shown.
The hooks (10) are used to hold the
dust bag.
NOTE: Make sure the hook (10) is
securely fastened to the corner of
the leg (2).
Fig. A
3. Attach one long upper support with
label (1) to top of leg (2) using one
bolt (3) and nut (4).
NOTE:
● Align detents (8) in stand leg
with support brackets to ensure
proper fit.
● Do not tighten bolts until stand is
properly aligned.
● Position all supports to the
INSIDE of the leg assembles.
4. Attach short upper supports (6) to
other hole of leg (2) using one bolt
and nut.
Fig. B
6
2
3
4
10
8
1
10
2
10
Front
7
5
1
6
2