CDA CERAMIC HOBS HVC65 - Manual (Page 15)

14
How to Install the Hob
How to install the hob:
Overall dimensions of the hob: HVC65 width 590mm depth 510mm
HVC75 width 770mm depth 510mm
Worktop cut-out dimensions: HVC65 width 560mm depth 490mm
HVC75 width 740mm depth 490mm
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker
hood to ensure that you will have the required clearance. The cut-out (Fig.12) shows a 60mm gap from the wall to the
cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to
be fitted, take this into account when cutting the hole. The minimum distance that the hob should be positioned away
from the rear wall or splashback is 50mm.
2. Position the hob seal, as shown in (Fig.14), ensuring that the ends meet without overlapping. Do not use silicone type
sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig.15). Remove any excess
sealant after tightening the brackets. Do not over-tighten the fixing brackets.
3cm
4cm
65mm
470mm
550mm
150mm 150mm
Fig.12 Fig.13
400mm
650mm
185mm 185mm
60mm
480mm
560mm
740mm
190mm 190mm
Fig.14 Fig.15